This is a replacement clip set of 2 ONLY for the second row seat latch that is commonly broken across GMT800 SUV's. This latch prevents the second row seat panel attached to the rear of the seat from falling into the floor, preventing anyone from sitting comfortably in the third row seats.
3D printed in ASA for exceptional strength and heat resistance, surpassing the OEM latch. This is just the center latch that commonly breaks, you will reuse your original housing with pin and spring.
To install simply remove the latch assembly from the rear seat by depressing both clips inward with thin flat head screw drivers or a pick. Then push the pin out of the original latch housing making note of which way the spring was seated. Install the new clip in reverse by partially inserting the pin through the thicker side until it protrudes slight out of where the spring will sit. Using a pair of needle nose pliers, position the spring in line with the pin and push the pin fully through the other side.
This includes all NBS 2000-2006 Tahoe, Suburban(1500 or 2500), Yukon, Yukon XL (1500 or 2500)
2001-2006 Yukon Denali & Yukon XL Denali
2002-2006 Escalade & Escalade ESV
You will receive a clips for each side for a total of 2
